Tile & Stone Installation
Southcrete™ 555 Type 1 Adhesive (SC555)(Premium Type 1 Adhesive [White])
Southcrete™ 555 is a contractor grade, white acrylic latex-based, Type 1 adhesive which will bond ceramic tiles to structurally sound, firm, dry surfaces. Applicable surfaces include gypsum wall panels, exterior-grade plywood, concrete, glass mesh, mortar units, and old, properly prepared floor tile or terrazzo. This product is non-flammable and emits no toxic fumes. Set Southcrete 555 with a long-lasting plastic grip, spreads easily. This product is water-resistant when dry and is freeze and thaw stable for storage.
Southcrete™ 555 will bond ceramic tiles to structurally sound, firm, dry surfaces such as Gypsum wall panels, exterior grade plywood (interior), plaster, and cementitous backer units
- New Anti-Slip Formula
- Easy Clean Up
Not to be used to set fixtures or marble. Do not use where hydrostatic pressure exists. Plywood surfaces should be limited to dry interior applications only. Surfaces such as particleboard, pressure or chemically treated wood, or synthetic flooring are not recommended. Interior use only.
- All surfaces must be clean, dry and free of wax, grease, scaly paint and foreign matter. Concrete surfaces must be fully cured (normally 28 days) and free of excessive moisture and alkalinity.
- All materials should be at minus 50-degrees for 24-hours before and 48-hours after installation.
Spread adhesive to substrate with trowel recommended for the material being set (see side panel of the container) hold the trowel at a 45-degree angle with the flat side of the trowel to ensure a good mechanical bond. Then re-trowel over by using the properly notched trowel. Apply no more adhesive than can be covered in 15 to 20 minutes depending on temperature and humidity. Press or twist tiles firmly into position (do not slide). Tap tiles with rubber-beating block to assure 100% contact with the adhesive. Do not set tiles after the skin has formed.
Under normal conditions wait 24 hours, then grout with SGM formulated wall or floor grouts.
Follow ANSI A 108.4 specifications. This product meets or exceeds ANSI A 136.1 Type I.
Approximately 50 to 60 sq. ft. per gallon with 5/32″ trowel. Approximately 30 to 40 sq.ft. per gallon with ¼” trowel.
One (1) year in unopened container.
CLEAN UP AND STORAGE
Remove excess wet adhesive with warm soapy water. Keep container closed after use and store at room temperature.
Keep out of reach of children; in case of eye contact, flush repeatedly with water and immediately contact a physician.
SGM, Inc. warrants this product will perform in accordance with its intended use for a period of one (1) year from the date of manufacture. Any claim for a defective product must be submitted in writing to SGM, Inc., and samples of defect must be provided. EXCEPT AS PROVIDED HEREIN, SGM, INC. MAKES NO OTHER REPRESENTATION OR WARRANTY OF ANY KIND, INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR PARTICULAR PURPOSE. IN NO EVENT SHALL SGM, INC. BE LIABLE FOR DAMAGES OF ANY KIND OR NATURE, WHETHER ARISING BY CONTRACT, TORT OR OTHERWISE. SGM, INC.’S SOLE OBLIGATION WILL BE TO REPLACE ANY PRODUCT DETERMINED BY SGM, INC. TO BE DEFECTIVE.